Log In or
Enter your e-mail address to receive our newsletter
Your basket is empty.
Hyperflow 56mm EDF Fan unit
This product is currently out of stock
Hover over image to zoom
Motor shaft diameter: 3mm
Weight (as shown in photo): 67 grams
KV: 6000 rpm/volt
ESC Timing: Low for Pentium Series ESCs (higher timing does not increase RPM only amp draw)
The newest version of the Wicked Extreme motor specifically designed for use in the Wemotec 50mm Micro fan. This is a perfect motor for use int he new line of 50mm jets sold by Jpower. This is intended for a 3S lipo setup in the Wemotec Micro fan.
Test data for 3S lipo: 32 amps, 360 watts, 60,300 rpm
The recommended lipo is a 3S 1800 mah lipo rated at 25C or higher. DO NOT SHORTEN THE THREE MOTOR WIRES UNDER ANY CIRCUMSTANCES. Shortening the motors wires will VOID any warranty and DonsRC will not service any motors or be held responsible for any collateral damage to ESCs, fan units, lipos, planes, etc when motor leads have been shortened. In other words don't do it!
NOTE: The use of bullet connector on the motor leads is NOT recommended. Direct solder the motor leads to the ESC leads with 1/4" overlap. Bullet connectors can cause issues that can lead to ESC failure and or motor failure. Use bullet connectors at your own risk.
Product Code: Wicked6000KV
eCommerce Software by CubeCart